QBU-series Pockels cell drivers

Pockels cell drivers of QBU-series differ with output voltage range, max 6.0 kV bipolar (see also How to order? section). Please, note that by bipolar device an output pulse voltage U is formed by applying +U/2 to positive output wire and –U/2 to negative.

QBU-series is specially designed to control Pockels cells by applying a fast switching high voltage. The modules require +24 V DC power supply and pulse generator to set an operating frequency and pulse width. An output voltage level can be programmed in working range by user either manually (through onboard configuration trimpot) or remotely (applying a DC voltage to the respective pin).

Triggering by an external low voltage arbitrary TTL signal allows modules to work in next scenarios:

• push-up (= normally off scheme), when a base voltage level equals to zero
• pull-down (= normally on scheme), when pulses from base bias voltage to ground are generated
• user-defined scheme, with arbitrary width and frequency of pulses.

Pockels cell drivers of QBU-series are based on MOSFET technology and offer high repetition rates and fast transition time (< 15 ns) for both pulse edges.

Performance

For instance, QBU-5020 kept cool enough and running with proper load (Pockels cell with 5‑7 pF capacitance plus 30-50 cm connective cable) has typical performance as below:

(*) The values are approximate, exact performance depends on actual load capacitance and cooling conditions.

In burst mode (i.e. for short term operations) the performance increases approximately twice and exceeds 100 kHz at low operating voltages and low load capacitances.

The performance deteriorates for higher load capacitance.

You may also be interested in:

Compact driver, up to 4 kV	Encased driver	Up to 10 kV output